Battery not charging — charger green light illuminated, doesn’t turn red to indicate charging Sondors StepBy Adam Seldow
Battery on 2019 Sondors Step will not charge. I plug the charger into it and charger light remains green (never turns red to indicate charging). I reset LCD to default just to make sure it want settings issue. Any ideas? I tried two different chargers as we ha e two of these bikes. When I remove battery and plug in to charger, 3 green dot lights turn on only when plugged in.
By Josh Davis
I just received a new KT LCD8H, and hooked it up with the new 35 amp controller I have. The pedal assist kicks on and off for no apparent reason. It will do it at any speed, so it's not a speed governor issue. The pedal assist will only work for about one second at a time and give me a burst of power and then cut off every couple of seconds. Is anybody know what could cause this, or how it could be fixed?
DIY: S-LCD3 Meter for Sondors eBike
This walkthrough is for those who purchased the non Sondors S-LCD3 with the white flat 5-pin connector. If you are not comfortible with soldering, then you may want to wait for the retail Sondors LCD in xmas 2015.
Walkthrough by Matt Moss
Downloadable at uberbills.com/DIY-SLCD3-Soldering.docx
S-LCD3 purchased from BMSBattery.com
Step 1: Attach LCD3 to handlebars
Step 2: Snip off the useless white flat 5-pin connector.
Step 3: Pull meter cable through top hole in sondors battery box. (no picture)
Step 4: Snip off the round 5-pin female plug and strip all the wiring down a half inch.
Step 5: Proceed to tin the stranded wire ends. tinning means to apply hot motlen solder to the stranded wire, which helps to solder two separate wires together.
Step 6: Admire your soldering job and apply insulation. I used cheap electrical tape, but you should spend a few cents and get some shrink tube.
Step 7: Double check that no exposed wire is showing, and test our your new lcd meter. Hold the center power button to turn on. To keep the backlight on for easy viewing, press and hold the up arrow. If you hold and press the down arrow, your bike will lurch forward at a walking speed, so be careful!
Q: I press and hold the up arrow like you said and my bike wants to go for a ride. What gives?
A: You installed your LCD button upsidedown. Reverse it and you should be fine.
Q: Halp! Why is my LCD screen upside down?
A: You installed your LCD screen upside down. /reverse it and you should be fine.
Q: After installing the LCD, I am unable to engage the throttle and the bike does not move, yet everything is on. What Gives?
A: Check that the LCD screen is actually on, you must have the LCD turned on in order for you to power your bike and use the motor.
If you have any questions, feel free to PM me (private eMails or information not permitted in open forum PM me).. Please include in the subject “Sondors Storm Owners Group”
If this walkthrough helped you in any way, please consider donating! Have a nice day!
paypal: private eMails or information not permitted in open forum PM me.